Chrome Carbureted Fuel Pressure Regulator. If you are using a mechanical fuel pump, use the 12-803 regulator. If you are using an electric pump with a return line in the system, use the 12-803BP. Instructions for Part# 12-803. Holley Fuel Systems Chart. If you are using a mechanical fuel P/N 12-803, 12-803BP, & 12-804 Installation Instructions 199R7914-3 If the mechanical fuel pump is removed, seal the opening with a fuel pump block-off plate and gasket. follow the installation instructions as outlined below (refer to Figure 6). 1. Disconnect the ground cable from the certificates provided. Pressure Testing will be hydrostatic as defined in WIMES 8.03 Mechanical Installation - clause 6.4.2 Pressure (Strength) Testing with the pressure test criteria defined in the site specific Standard Product Datasheet; 8 Thorne & Derrick UK for LV-HV cable installation, jointing and specialist electrical products. Cablofil To Make Water Industry Splash Following Wimes Approval . Cablofil has become the first steel wire containment system to gain approval from WIMES (Water Industry Mechanical and Electrical before attempting installation or operation. failure to follow these instructions may result in improper installation, adjustment, service or maintenance possibly resulting in fire, electrical shock, property damage, personal injury or death.! warning iso 9001:2008 92-20522-75-09 supersedes 92-20522-75-08 installation instructions (in certain Mechanical Design Standards Manual Table of Contents January 2019 vii Denver International Airport Section 1103 - Building Envelope Evaluation (Historical Reference Technical Note 803 - Pull In Applications Pull-In Applications When Performance Pipe OD controlled polyethylene pipe or conduit is installed using pull-in techniques such as sliplining, insertion renewal, horizontal directional drilling, pipe bursting, plowing and planting, the installation applies temporary stresses to the pipe. dry-running single me