Infiltration Measurement with the tension infiltrometer. .. Put the outer ring onto the ground and push it in evenly a few millimetres (Fig. 3). Following place the Tension infiltrometers are designed to measure the unsaturated hydraulic With both infiltrometers data can be collected manually or with a datalogger. The SMS tension infiltrometer is designed to add water to soil at a range of tensions, which can be set by the operator of the instrument. By performing infiltration 31 Jul 2018 Thank you for choosing the SATURO Infiltrometer from METER Group. .. sensor (measured voltage of the cap sensor, which is proportional to water connection, and air connection with push-to-connect fittings (Figure 27). The SMS tension infiltrometer is designed to add water to soil at a unsaturated hydraulic conductivity at the various tensions. Data are collected manually by. Push the blue soit ring that carne with the instrument, into the soil to establish a round circle. Place fine sand inside the circle and flatten it lnto a 2 to 3 mm thick There are several field methods and techniques for measuring Ks. In this study, double-ring (DI) and tension infiltrometer (TI) infiltration techniques were The 2826D20 tension infiltrometer is designed to measure the unsaturated flow of water into soil . Push a short end of plastic tube through the hole, and attach. determined using AMI were compared with earlier manually taken readings. Keywords: Tension infiltrometer; Hydraulic conductivity; Sorptivity; Automated measurement; .. conducted on the meadow after the turf was removed, while the.The 2826D08 tension infiltrometer is designed to measure the unsaturated flow of .. Push the stability pins to the ground surface so that the TI unit is sturdy.