"Chez Instron, notre objectif est d'apporter a nos clients la meilleure experience utilisateur en leur fournissant des produits de la plus haute qualite, une expertise et un service de classe mondiale." Yahya Gharagozlou President du Groupe Test & Measurement, ITW Operation of the Instron Tensile Test Machine . With an Existing Method in Bluehill 3 Software . Introduction by . Andrew E. Frerichs, 3/25/11. Michelle Grawe; 10/6/14 . Introduction . The Instron device is a displacement controlled load frame. This means that the crosshead is raised or lowered by turning screws located on either side of the frame. Product life cycle table with Instron model numbers and their corresponding Life Cycle phase. We use cookies to improve your browsing experience. By continuing to use our site, you accept our cookie policy . The Instron 3340 Series Single Column Testing Systems are suited for tension and/or compression applications where tests are less than 5 kN (1,100 lbf) and lab space is limited. They are typically used for quality control and production testing. Four single column models are available in load capacities Instron FastTrack 8800 Materials Test Control System M21-10011-EN Revision C www.instron.com. Electromagnetic Compatibility Where applicable, this equipment is designed to comply with International Electromagnetic Compati- Carefully read all relevant manuals and observe all Warnings and Selling a used Instron 5542P8501 tensile tester with manu accessories (foot switch, software, 2712-014 pneumatic grips, etc) Unit was functioning when removed for storage. For sale purposes assume the Instron Tensile Tester, model 1011, 120v, 30 day warranty, nice unit . Note: Accessories such as grips, fixtures, extensometers, etc. are not covered in this table. Your frame may be fitted with accessories that fall into a Phase 3 or 4 category. Whenever in doubt, we ask that you reach out to your local Sales Representative for clarification. Instron 5585 Ma